Frame the Song
Menu
Skip to content

Shot craft Craft Some effort90 min

How to write a music video shot list, with a worked example

Build a shot list for a three-minute song in 90 minutes: song map, shot counts, lengths in seconds and a shoot-day order.

Frame the Song Editors 4 min read

What is a music video shot list for?

A shot list tells everyone what the camera does at each moment of the song, so nobody has to decide it on the day. Your treatment says what the video feels like. The shot list says that at 0:38, on the first chorus, the camera sits at chest height on a 35mm lens and pushes in over four seconds. With that line in hand, a friend holding a light knows what to set up next, and you know when you have enough footage to cut the whole song. A shoot without a list tends to come home with forty minutes of the same wide shot and nothing for the second verse.

What do you need before you start?

You need a locked mix, a lyric sheet and somewhere to type, plus 90 minutes. Lock the mix first, because one change to the arrangement moves every time in the list.

  • The final audio file, with its length in minutes and seconds
  • The lyrics printed, with wide margins for timings
  • A spreadsheet, or StudioBinder, whose free plan holds one project and up to 10 shots in a shot list
  • Your treatment, or one sentence that states the idea

A three-minute song needs around 40 rows. That is past the StudioBinder free limit, so use a spreadsheet for the whole song and keep StudioBinder for planning one section.

What are the steps, in order?

Work through six steps in this order and a three-minute song takes 90 minutes.

  1. Map the song (15 minutes). Play it three times and write the start time of every section in minutes and seconds.
  2. Pick three to five setups (10 minutes). A setup is one location, one light and one camera position that you build once.
  3. Give each section its shots (30 minutes). Say which setup serves each verse, chorus and bridge, and how many shots it needs.
  4. Fill in the columns (20 minutes). Shot number, song time, framing, action, length in seconds.
  5. Check the sums (10 minutes). The shot lengths in each section must add up to the length of that section.
  6. Reorder for the shoot (5 minutes). Sort a copy by setup, and keep the song time column so you can sort back.

How long should each shot hold?

Hold verse shots for 5 to 8 seconds and chorus shots for 2 to 4 seconds, and land every cut on a bar line. At 120 bpm a bar lasts 2 seconds, so a four-bar shot runs 8 seconds, which is 200 frames at 25 fps. A slow ballad can hold 10 seconds or more, because a slow push-in beats a quick cut when the singer is carrying the line.

Here is a map for a 180-second song: intro 8 seconds, verse one 30, chorus 25, verse two 30, chorus 25, bridge 20, final chorus 30, outro 12. With 6 second verse shots, 3 second chorus shots and 10 second bridge shots, that comes to about 40 shots.

What does a finished row look like?

A finished row holds a number, a song time, a framing, an action and a length in seconds. Here are the first three rows for a kitchen performance, filmed at a home where you have the owner’s permission.

  1. 0:00. Wide on the doorway, singer’s back to camera, window light at 5600K. Holds 8 seconds.
  2. 0:08. Medium at chest height, 35mm, singer at the sink mouths the first line, slow push-in. Holds 6 seconds.
  3. 0:14. Close on hands round a mug, kettle steam rising. Holds 6 seconds.

Add a light column if you plan to grade later. Every row should be specific enough that a stranger could set up the shot without asking you a question.

What if it goes wrong or you run out of energy?

Write the chorus shots first and repeat setups for everything else. The choruses carry the video, so if you have 30 minutes left and a half-empty list, finish them, then give each verse two setups you already have and let the edit repeat them. If the sums will not match, change your longest shot rather than adding a new one. If a shot needs a location you cannot get, swap it for a close-up in a setup you already have. Cutting back to 25 shots for a 180-second song is fine. A list you finish beats a perfect one you abandon at row 18.

Common mistakes, and an easier next time

The most common mistake is giving every shot its own setup. Watch for these four:

  • A new location for each row, which turns a 90-minute list into a three-day shoot
  • No lengths in seconds, so you cannot check the list against the song
  • One framing per take, when a wide, a medium and a close-up of each performance gives the edit choices
  • A list in song order only, so you change the light six times in one day

Next time, keep the finished spreadsheet as a template with the columns already set. Write the list on the same day as the treatment, while the idea is still clear in your head.

Frequently asked questions

How many shots should a music video have?

A three-minute song with 5 to 8 second verse shots and 2 to 4 second chorus shots comes to about 40 shots. A slow ballad that holds each shot for 10 seconds or more lands closer to 20.

What columns does a music video shot list need?

Shot number, song time, framing, action and length in seconds. Add a light column and a setup column if you want to sort the list for the shoot day.

Can I use the free StudioBinder plan for a music video shot list?

The free plan allows one project and up to 10 shots in a shot list. That covers one section of a song, such as a chorus, but a full three-minute list of about 40 rows needs a spreadsheet or a paid plan.

What is the difference between a shot list and a storyboard?

A shot list is rows of text with timings, and a storyboard draws the frames. Write the shot list first, then draw only the shots you are unsure about. Boords handles shot lists and storyboards in one place.

How long does a shot list take to write?

About 90 minutes for a three-minute song, once the mix is locked. Most of that time goes on giving each section its shots and checking that the lengths add up.